Miller® CFS-2 Series Fiber Optic Jacket Removal Device

Miller® CFS-2 Series Fiber Optic Removal Tool for 900µm and 250µm - Dual Hole

• CFS-2 900 for stripping 250 and 900 micron buffer coating to expose 125 micron cladded fiber
• First hole application: 1.6 - 3 mm Jacket → 600 - 900 µm Tight Buffer
• Second hole application: 900 µm Tight Buffer & 250 µm Buffer Coating → 125 µm Bare Fiber
• Pre-set at the factory—no adjustments needed
• Will not scratch or nick glass fiber
• All stripping surfaces are manufactured to precise tolerances to assure clean, smooth strips
• Comfort-grip, ergonomic handles
• Lock to hold tool closed when it is not in use
• Made in China
• Length: 6.5 in (165 mm)
• Weight: 4.2 oz (119 g)
• CFS-2 900
• Always make sure the fiber stripping notch is clean of any debris

Fiber Optic Stripper Operation Instructions:

1. The larger notch at the tip of the tool can remove fiber jackets of 2mm to 3mm. Holding the tool firmly, close it around the jacket and remove the jacket material.
2. If there are Kevlar members, cut them with a Kevlar cutter.
3. The smaller notch close to the pivot point of the tool, in a single step, you can remove 900 µm & 250 µm coatings to expose the 125 µm fiber
   1. Insert the fiber
   2. Close the tool completely, but do not squeeze hard. Depending on the fiber construction, if you angle the tool it may make it easier to strip
   3. Pull the tool towards the end with steady pressure